Changing the holding pattern line to a curve

The Curved Holding Pattern tool allows you to change the holding pattern line depiction in a profile view from the existing depiction to a curved line. The curved line is attached to the associated vertical line at two nodes. Changing the holding pattern portrayal indicates when or where in the holding pattern it is safe to change altitudes and/or descend.

The curved line created is as wide as the length of the original holding pattern line. You can move the end points of the curve along the vertical line to make the arc smaller or larger.

Étapes :

1. Start ArcMap.
   Conseil :

   If the ArcMap - Getting Started dialog box appears, you can open a new or existing map document. You can also check the Do not show this dialog box in the future check box and click Open.

2. On the main menu, click View > Layout View.
3. On the main menu, click Customize > Toolbars > Aeronautical Terminal Procedures.
4. On the main menu, click Customize > Toolbars > Aeronautical Profile Edit.
5. Click the Edit Instrument Approach Profile button on the Aeronautical Terminal Procedures toolbar.
6. Select a holding pattern inside the profile view element.
7. Click the Curved Holding Pattern button on the Aeronautical Profile Edit toolbar.

   The selected holding pattern updates with an arc depicting a curved holding pattern.

   Conseil :

   If there is not enough room in the profile view for the curved line on the default side of the vertical line due to other profile view elements, you can flip the entire holding pattern depiction to the opposite side of the vertical line to alleviate congestion.