Point reporting

This topic applies to ArcEditor and ArcInfo only.

The point report tool displays information on the selections of one point, two points, and three points. To open the Point Report dialog box, click the Point Reporting On 1, 2 Or 3 Points tool Point reporting on 1, 2, or 3 points on the Parcel Editor menu.

One point

When one point is selected, the following information is displayed on the Point Report dialog box:

Report on one selected point
Report on one selected point

To generate a report for one point, open the Point Report dialog box, click the point for which you want to generate a report, then click the Report button.

Two points

When two points are selected, the point report tool generates information on the position of the points relative to each other. The following data is listed on the Point Report dialog box:

Report on two selected points

To generate a report for two points, click the middle button on the Point Report dialog box. Click the two points for which you want to generate a report and click Report.

Three points

When three points are selected, the point report tool generates information about the offset of the third selected point relative to the line created by the first two selected points. The following data is listed on the Point Report dialog box:

Point report on three points
Point report on three points

To generate a report for three points, click the third button on the Point Report dialog box. Click the three points for which you want to generate a report and click Report.

TipTip:

Angles and directions displayed on the Point Report dialog box are displayed in the units currently set for Editor. To change Editor units, click the Editor arrow on the Editor toolbar and click Options. On the Editing Options dialog box, click the Units tab.


5/6/2011